Supplies:
Stamps: Best Year (cling 152568)
Ink: Cherry Cobbler Classic Stampin' Pad (147083)
Paper (including Cutting Dimensions):
Evening Evergreen Cardstock [CS] (155574) 3-1/2” x 5”
Very Vanilla Cardstock [CS] (101650) scrap
Brushed Metallic Cardstock [CS] (153524) Gold 3-1/4” x 3-1/4”, 2-3/4” x 5”
Simply Elegant Specialty Designer Series Paper [DSP] (155761) White/Gold 2-3/4” x 3-1/4”, 2-1/2” x 5”
Accessories:1/4" Gold Shimmer Ribbon (152156) 3”, 4-1/2”, 3/8" Open Weave Ribbon Evening Evergreen (155573) 4-1/2”, Wonderful Gems (153536), Painted Texture 3D Embossing Folder (154317), Basic Borders Dies (155558), Seasonal Labels Dies (156299, Stampin’ Spritzers (126185), Take Your Pick (144107), Note Cards & Envelopes - Very Vanilla (144236), Bone Folder (102300), Multipurpose Liquid Glue (110755), Stampin’ Seal+
(149699), Stampin’ Dimensionals (104430), Mini Glue Dots (103683), Simply Shammy (147042) or Stampin’ Scrub (126200)
Stampin’ Mist Stamp Cleaner (153648), Grid Paper (130148) or Small Grid Paper (149621)
Paper Snips (103579), Paper Trimmer (152392), Stampin’ Cut & Emboss Machine (149653) or Mini Stampin’ Cut & Emboss Machine (150673)
Instructions:
1. Fold Note Card Base; burnish crease with Bone Folder. Set aside.
2. Fill Spritzer with water; lightly mist Evergreen CS then emboss with Texture folder.
3. Stamp sentiment with Cobbler ink on Vanilla CS; cut out with Labels Die.
4. Attach smaller DSP to square Metallic CS with Seal+. Wrap layer with Evergreen Ribbon securing ends on back with Glue Dots. Add larger Gold Ribbon over Evergreen Ribbon securing ends on back with Glue Dots.
5. Cut large DSP and large Metallic CS with arch-shaped Borders Die. Attach DSP die-cut to Metallic die-cut with Seal+ placing so top edge of DSP is about 1/4” below top edge of Metallic CS. (See Photo 2.) NOTE: Lower edges of layered pieces will not match; they will be trimmed in Step 6.
6. Assemble Holder as follows:
- Attach Evergreen embossed CS to Note Card with Seal+;
- Add DSP/Metallic CS/Ribbons layer with Seal+;
- Tie overhand knot with smaller Gold Ribbon and attach with Glue Dot;
- Add sentiment die-cut with Seal+ on DSP and Dimensional on embossed CS;
- Add Gems with Take Your Pick; and,
- Attach DSP/Metallic die-cut to inside with line of Liquid Glue along only outside edges; let dry. Trim excess along lower edge with Snips.
