An extra special gift deserves an extra special tag. Create these 3D tags by folding patterned paper then twisting them flat to create a Rosette. Add a pretty ribbon and a
scalloped base for a unique tag.
SUPPLIES
Stamps:
To add To/From on your tag, use the stamp sets Celebrate with Tags (159974), Handmade Wishes (159684), or Spruced Up
(159694).
Ink:
Evening Evergreen Classic Stampin’ Pad (155576) optional for To/From stamps
Paper (including Cutting Dimensions):
Evening Evergreen Cardstock {CS} (155574)
scrap
Pear Pizzazz Cardstock {CS} (131201) 4” x 5” [Base]
Real Red Cardstock {CS} (102482) 4” x 5” [Base], scrap
Painted Christmas 12″ x 12″ Designer Series Paper {DSP} (156292) for each Rosette: 1-1/2” x 12” scored at 1” and then each additional 1”; flip
DSP over, score at 1/2” and then each additional 1”. You will have a crease every one-half inch across the entire strip.
Accessories:
3/8″ Shimmer Ribbon – Gold (156470) 12”, 3/8″ Windowpane Check Ribbon – Evening Evergreen (158135) 12”, Baker’s Twine Essentials Pack (155475) Crumb for each Tag 7”,
Adhesive Sheets (152334) for each Rosette 2” x 2”, 2-1/2” x 2-1/2”, Label Me Fancy Punch (151297), Layering Circles Dies (151770) 2nd smallest scallop,
Scalloped Contours Dies (155560) 2nd largest rectangle, Small hand-held stapler, Hot Glue Gun/Glue Sticks, Several medium to large Clear Acrylic Blocks,
Bone Folder (102300), Stampin’ Seal+ (149699),Mini Glue Dots (103683), Stampin’ Cut & Emboss
Machine (149653) or Mini Stampin’ Cut & Emboss Machine (150673)
INSTRUCTIONS
1.Cut Base from CS with Contours Die. Add string hole with Fancy Punch.
2.Attach small Adhesive Sheet square to CS
scrap; cut small circle with Circles Die.
To make Rosette:
-Score DSP as noted above and burnish each crease with Bone Folder; turn DSP over and burnish each crease again;
-Secure ends, right sides together, with Seal+ to make circle. Secure taped area with
two staples close to score line.
-Add large Adhesive Sheet square to center of Base then add puddle of hot glue to center of Sheet;
-Flatten Rosette over Adhesive/Glue and then place several Blocks on top and allow Glue to harden;
-Remove Adhesive liner
from CS then add puddle of hot glue to back of CS; remove blocks and then attach CS over center of Rosette; and,
-Replace Blocks and then set aside to allow Glue to harden.
3.Tie bow and then attach with Glue Dots.
4.Add Twine through string hole and tie to
package.