Supplies
Stamp Sets: Magical Meadow (162134) *
Inks: Versa mark (102283)
Paper: Basic White (159276), Smoky Slate (131202), Basic Gray (121044),
Gray Granite (146983), Winter Meadow 12” x 12” Designer Series Paper (162133), Snowflake Magic 12 x 12” Specialty Designer Series Paper (162147)
Other: Stampin’ Cut & Emboss Machine (149653), Heat Tool (129053), Magical Meadow Dies (162143), Tailor Made Tags Dies (155563), Basics Embossing Powders (155554), Paper Trimmer (152392), Silver & White ½” Sheer
Ribbon (162149), Faceted Gems Trio Pack (162148), Paper Snips Scissors (103579), Multipurpose Liquid Glue (110755), Bone Folder (102300),
*Purchase together in Magical Meadow Bundle (162144) together and save 10%
Measurements
- Smoky Slate (card base): 7 ¼” x 5 ½”; scored at 4 ¼”
- Smoky Slate (holly):
scraps
- Gray Granite (holly): scrap
- Basic White (inside): 5 ¼” x 4”
- Basic Gray (tag): 4 ½” x 2 ½”
- Basic Gray (mat for Designer Series Paper): 2 7/8” x 5 3/8”
- Winter Meadow DSP (front): 2 ¾” x 5 ¼”
- Snowflake Magic DSP (inside): 1 ¼”
x 5 ¼”
- Ribbon: 5” cut in ½ lengthwise
Instructions
- Fold the Basic Gray cardstock on score line to form card base. Use the Bone Folder to get a good crease.
- Glue the Winter Meadow
Designer Series Paper to the Basic Gray mat and glue both to the front panel.
- Glue the strip of Snowflake Designer Series Paper to the Basic White and glue to the inside of the card.
- Cut out the tag from the Basic Gray using the Tailor Made Dies
and Stampin’ Cut & Emboss Machine.
- Ink the sentiment in Versamark and stamp on the tag, apply White Emboss Powder and heat set.
- Trim off ½” from the right side of the tag and line up edge with the left side of the inside
layer.
- Cut the ribbon in ½ lengthwise and thread both pieces through the hole in tag and tie in a bow.
- Cut out two holly dies from the scrap of Smoky Slate and one holly from the scrap of Gray Granite and glue to the tag as shown in
picture.
- Add Faceted Gems to the tag to finish the card.
